Introduction to the virtual lab

Step One: Set the table view to show just the MPR and Lesson panels.

1. Tap once on the View icon in the toolbar
2. Tap once on 3D to remove the 3D panel

Step Two: Remove the Coronal and Sagittal planes from the multi-cross section (MPR) panel so that only the Transvere plane appears

1. Tap once on the Rotate tool to select it
2. Using one finger, tap twice on the Transverse plane

Step Three: Adjust the tranverse plane until it matches the CT scan

1. Using three fingers, swipe up and/or down the Transverse plane
2. Continue adjusting the plane until it matches the CT scan